Brain electrical activity was recorded continuously by using a Hydrocel Geodesic Sensor Net, consisting of 128 silver–silver chloride electrodes evenly distributed across the scalp (Fig. 2). The vertex served as the reference. The electrical potential was amplified with 0.1–100 Hz band-pass, digitized at a 500 Hz sampling rate, and stored on a computer disk for offline analysis. The data were analysed using NetStation 4.2 analysis software (Electrical Geodesics Inc., Eugene, OR, USA). Continuous EEG data were low-pass filtered at 30 Hz using digital elliptical filtering, and segmented in epochs from 100 ms before until 700 ms after stimulus onset. Segments with eye-movements and blinks were detected

visually and rejected from further analysis. Artefact-free data were then baseline-corrected to the average amplitude of the 100 ms interval preceding stimulus onset, and re-referenced to the average potential BGB324 clinical trial over the scalp. Finally, individual and grand averages were calculated. Statistical analyses of the ERP data focused on sites close to somatosensory areas (Frontal sites, F3 and F4: 20, 24, 28, 117, 118, 124; Central sites, C3 and C4: 35, 36, 41, 103, 104, 110; Centroparietal sites, CP5 and CP6: 47, 52, 53, 86, 92, 98; see Fig. 2; see, for example, Eimer & Forster, 2003). SEPs at these sites were observed to be the largest across both of the experiments

and DAPT solubility dmso showed the typical pattern of somatosensory components in response to tactile stimuli (P45, N80, P100 and N140). For each participant, we calculated the difference waveform between posture conditions for ERPs contralateral and ipsilateral to the stimulated hand. To establish the precise onset of the effects of remapping on somatosensory processing, a sample-point by sample-point analysis was carried out to determine whether the difference waveform deviated reliably from zero. Based on previous

evidence suggesting that postural remapping is apparent in behaviour within 180 ms (Azañón & Soto-Faraco, eltoprazine 2008) we sampled across the first 200 ms following stimulus onset. This analysis corrected for the autocorrelation of consecutive sample-points by using a Monte Carlo simulation method based on Guthrie & Buchwald (1991). This method began by estimating the average first-order autocorrelation present in the real difference waveforms across the temporal window noted above. Next, 1000 datasets of randomly generated waveforms were simulated, each waveform having zero mean and unit variance at each time point, but having the same level of autocorrelation as seen on average in the observed data. Each simulated dataset also had the same number of participants and time-samples as in the real data. Two-tailed one-sample t-tests (vs. zero; α = 0.05, uncorrected) were applied to the simulated data at each simulated timepoint, recording significant vs. non-significant outcomes.