4B). Compared with other methods that are strongly affected by data size, our RVB method was robust against large variations in data size. The REM method also worked well in relatively broad ranges of Selleck Nutlin-3 the data size. In contrast, NEM and NVB for normal distributions showed no such robustness. In particular, the number of normal distributions (i.e. clusters) increased proportionally to data size when the data was generated by t-distributions (Fig. 4A). The Student’s t-distribution possesses longer tails than the Gaussian
and produced outliers, which could be covered only by an excessive number of normal distributions (Ripley, 1996; Svensén & Bishop, 2005; Archambeau & Verleysen, 2007). The better performance of RVB and REM is consistent with the fact that a t-distribution can be written by an infinite sum of Gaussian distributions (Student, 1908; Lange et al., 1989; Peel & McLachlan, 2000). Although some methods for normal distributions were reasonably good in the analysis of extracellular/intracellular check details recording data, the above results encourage us to use the RVB method. The primary purpose of the present study
was to develop a method to accurately perform spike sorting that requires minimal manual operation. Two types of error in manual operations were previously considered in detail (Harris et al., 2000). Commission errors (or false-positive errors) occur when spikes belonging to different neurons are grouped together, whereas omission errors (or false-negative errors) occur when not all spikes emitted by a single neuron are grouped together. Some human operators made
false-negative errors more often than false-positive errors, whereas others exhibited the opposite tendency. The manual-operation results were significantly impinged by the subjective bias and level of experience of each operator. The RVB-based method could accurately sort simultaneous extracellular/intracellular recording data, generating just a few percent of false-positive and false-negative errors (Fig. 5). We found that smaller values of zth tend to suppress the percentage of false-negative errors at the cost of a small increase in the total error (data not shown). As false negatives can affect spike coincidence analysis more strongly than false positives MTMR9 (Pazienti & Gruen, 2006), a zth value of 0.5 to 0.8 is recommended (here, zth = 0.8). In summary, we developed an accurate and efficient method to spike-sort multi-unit data, based on the WT and RVB. This sorting method significantly improved the reliability of spike sorting to reduce the labor and bias of manual operations. The developed software, EToS, is freely available at http://etos.sourceforge.net/. This work was partially supported by a Grant-in-Aid for Scientific Research on Priority Areas from MEXT (nos. 17022036 and 20019035). T.T. was supported by the RIKEN Special Postdoctoral Researchers Program.