The value of the friction changes depending on the normal force generated by the magnetic coupling. The lowest friction occurs when the gap is the widest (the first stage) and exactly before a jump of the rotor from the lower to the upper sapphire bearing. What is more, when the rotor levitates, the friction occurs just on the cylindrical borders of the sapphire bearings. What is interesting

is that the lowest friction Crizotinib mw value is not achieved during the levitation stage, as might have been expected. This means that the friction on the cylindrical borders of the bearings has a relatively high participation in the absolute friction on the bearings. The next step of the calibration was measuring the inertia of the rotor. It was determined for a specific measurement geometry. This function allows to specify whether there are any impurities on the surface of the rotor. In order to distinguish the statistical results, measurement was repeated five times. The final value of the inertia was calculated as an average from five measurements, and introduced to the settings

of the rotor. Subsequently, the www.selleckchem.com/Wnt.html procedure of MSC used for defining the microstrains which are generated during the operation of the rheometer was performed. The appointed value should be included for the current rotor used. The MSC values are subtracted from the results obtained during the relevant measurements. The final step of calibration was the calculation of the friction correction parameters. For this purpose, the dependence of the friction on the sapphire bearings in the function of the rotation speed was determined. It is important selleck screening library to set the extent of the share rates in which the pressure chamber will be used because the same range should be applied during an appropriate measurement. Thus, it was the so-called ‘on empty’ measurement, i.e. without the sample in pressure chamber. A range of share rates from 0.01 to 1,000 s −1 in time of 1,610 s was assumed.

The resistances of friction depending on a rotation speed might be approximated with a mathematical equation: (1) where M e is the torque measured in empty chamber [ μNm], Ω is rotation speed [1/min], and a [ μNm/(1/m i n)2], b [ μNm/(1/m i n)], c [ μNm] are constant parameters of the quadratic polynomial. The parameters of the quadratic polynomial were fitted to the measurement data. Results of calculation of the friction correction parameters are presented in Figure 3. This procedure can also be used to offset the impact of the friction in bearing in electrorheological measurements so the result on the application of this procedure in electrorheology is also shown in Figure 3. Figure 3 Sample on determination of friction correction parameters for pressure chamber and electrorheology system. These correction parameters a, b, and c have to be introduced into the properties of the rotor as ‘torque correction’ in the RheoWin software.