After deposition, the cryostat and the samples reached RT in a natural heat exchange process lasting up to 12 h and then the chamber was filled with nitrogen. Before morphology characterization in ambient conditions, the samples were kept in an Ar (6 N) atmosphere. Scanned AFM images Atomic force microscope (AFM) measurements under tapping mode in air were carried out utilizing an Ntegra NT-MDT microscope (Moscow, Russia) equipped with sharp etalon probes with 10-nm tip curvature radius and 5:1 aspect ratio.
Such probes are Selleck BLZ945 characterized by highly reproducible parameters: typical dispersion of probe resonant frequency is ±10% and typical dispersion of force constant is ±20%. The resonant frequency of the probes is equal to 140 kHz, which corresponds to a force constant of 3.5 N/m. To calibrate AFM scanner movements along the z-axis, highly oriented pyrolytic graphite was used. Calibration in the lateral direction was performed using a three-dimensional array of rectangles with 3-μm period. X-ray reflectometry and diffractometry The structure of thin films was analyzed by X-ray reflectometry; the measurements were performed using the Bruker
Discover D8 X-ray diffractometer (Madison, WI, USA) with Cu Kα line source of wavelength 0.15405 nm and point detector. The monochromatic parallel beam was formed by a parabolic Goebel mirror. The data analysis was based on finding the proper electron density profile, whose Fourier transform would match the recorded www.selleckchem.com/PARP.html X-ray reflectometry (XRR) pattern. To fit the data, a ‘box model’
was used. Data fitting was performed using Leptos 4.02 software package provided by Bruker. The thickness and density of Ag and Ge layers as well as Ge/Ag and Ag/air surface roughness aminophylline were free parameters in the fitting procedure. The wide-angle X-ray diffraction (XRD) measurements were done with the Bruker GADDS system equipped with 2D Vantec 2000 detector. Results and discussion Effect of thermal expansion Deposition of metal layers on cooled dielectric substrates poses a question about the relationship between the dimensional stability of structures and temperature change. A mismatch of thermal expansion coefficients of layers gives rise to intrinsic stress that may result in metal film cracking. The thermal expansion coefficient of silver α Ag varies from 13.38 at 85 K to 18.8 [μm/m K] at RT [23]. At temperatures from 90 to 295 K, the expansion coefficient of sapphire α sapphire in the (0001) plane increases from 3.3 to 6.5 [μm/m K] [24]. The temperature difference between the cooled substrates and RT (at which samples are usually removed from the vacuum chamber) can be as much as 200°.